• Iona

Dairy Thermometer

I was asked the other day – where did we get our dairy thermometer from and why and when do we use it?

Two Thermometers

Our main thermometer ETI Therma 25T

Our main thermometer ETI Therma 25T

We have two dairy thermometers, both are made by ETI.  Both have one decimal place digital read outs.  We have two to double check that both read the same and in case one breaks or for some reason gives false readings.  I bought them from e-bay and both came with 12 month HACCP certificates – necessary for our BRC accreditation.  And because of this, we have to buy new replacement ones each year.  We used to have an all singing, all dancing thermometer, with test caps etc, but it cost more to send it away to be serviced each year than to buy a new lower end model that gives the same results.

I like the Therma 25T as it is easy to hold and is water resistant.

Our back up is a white thermapen as in the picture on the right. It clicks on when you open the probe and shuts off when you close it back.  It’s ok to use, but can be fiddly if you have wet hands.  Like the Therma 25T, it also has 0.1°C resolution. 

White ETI thermapen

White ETI thermapen

Here is my check list in buying a thermometer:


Buy one with a long-ish probe so that you can get a decent coverage around the probe to be as accurate as possible

Get one that has a HACCP certificate with it – and check before you buy, how old is the HACCP certificate as they are only valid for one year

Get one with one decimal place as there is a world of difference between 33.1 oC and 33.9oC.

Perform regular checks that your thermometers are in line with each other, so you be sure that they are accurate

Have a spare, not just to check accuracy but in case one conks out at a crucial stage – it is for this reason that we have two aciditymeters, and I tell you what, there have been times when we’ve needed the spare


Don’t buy a thermometer with mercury – could be slightly catastrophic if it were to break in or near the milk

Don’t use a thermometer made of glass – I am sure you already know: glass and dairies do not mix

I personally do not recommend a floating thermometer as you are only taking a reading on the surface of the milk which will be warmer closer to the source of heat.  They are also a bugger to clean as they are usually enclosed in a plastic sort of cage

I also do not recommend an infra red thermometer as I do not believe they are accurate enough and also only measure the temperature at the surface of a liquid or mass.  Our EHO pasteuriser tester uses one and it can differ from our thermometers by 2 degrees C, which in my book is significant.

When we use our thermometer

About every 10 minutes!  We check the incoming temp of the milk on pasteurisation as a sort of safeguard that all is well with the pasteuriser.  We use it to check the progress of heating the milk and ripening to know when we need to turn the vat off.  We check the temp of the curd whilst rennetting, particularly important in our little dairy when it is cold.

We use it to bring the curd to scald, gently over a slow period – we do not want to scald too quickly.  Once the whey is taken off, the curd channelled, blocked and cut, we generally stop taking the temperature of the curd, unless it is behaving oddly, in which case, we will check it.  But we do continue to take the temperature of the vat jacket which is another indicator of progress.

#cheesemaking #dairythermometer #ETI

9 views0 comments

Recent Posts

See All